Table of Contents
Advertisement
6-3-114 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE)
Test
Work Order Description
T04
Check: Short to Voltage of Voltage Supply Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
Camshaft Position Sensor
• Ignition ON
• Measure voltage between the following terminals:
MAF and IAT Sensor – Wiring harness connector (wiring harness side)
terminal C79-4
&
Ground
• Disconnect each of the following components/control units consecutively
from the wiring harness and repeat the measurement each time:
Pedal Position Sensor
Yes: E02
Nominal Value
4.8 ... 5.2 V
No: E04
Advertisement
Table of Contents
