Table of Contents
Advertisement
Test
Work Order Description
T05
Check: Interruption in Wiring Harness
• Measure resistance between the following terminals:
Fuel Pressure Sensor – Wiring harness connector (wiring harness side)
terminal C40-2
&
ECM – Wiring harness connector (wiring harness side) terminal C66-38
Yes: E01
T06
Check: Short to Voltage/Ground/Interruption of Signal Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
Fuel Pressure Sensor
• Ignition ON
• Measure voltage between the following terminals:
Fuel Pressure Sensor – Wiring harness connector (wiring harness side)
terminal C40-3
&
Ground
Yes: E06
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-167
Nominal Value
less than 5 Ohm
No: E02
greater than 5.2 V
No: E07
Advertisement
Table of Contents
