Table of Contents
Advertisement
Test
Work Order Description
T06
Check: Short to Voltage of Voltage Supply Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
A/C Pressure Sensor
• Ignition ON
• Measure voltage between the following terminals:
A/C Pressure Sensor – Wiring harness connector (wiring harness side)
terminal E26-1
&
Ground
Yes: E06
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-239
Nominal Value
greater than 5.2 V
No: E07
Advertisement
Table of Contents
