Suzuki Ignis Service Manual page 1935

6-3-276 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE)
Test Work Order Description
T23 Check: Component
• Install electrical component to socket:
Radiator Fan Relay No.1
• Measure voltage between the following terminals:
ECM – Wiring harness connector (wiring harness side) terminal G88-7
&
Ground
Yes: T24
T24 Check: Component
• Connect fused jumper wire to:
ECM – Wiring harness connector (wiring harness side) terminal E27-7
&
Ground
• Measure voltage between the following terminals:
Radiator Fan Motor – Wiring harness connector (wiring harness side) ter-
minal E44-2
&
Ground
Yes: T25
T25 Check: Component
• Connect wiring harness connector to:
Radiator Fan Motor
• Connect fused jumper wire to:
ECM – Wiring harness connector (wiring harness side) terminal G88-7
&
Ground
• Ignition ON
Yes: E15
Nominal Value
greater than 11 V
No: E11
greater than 11 V
No: E11
Is radiator fan run-
ning at low speed?
No: E12