Suzuki Ignis Service Manual page 1742

Test Table (For RB413D)
Test Work Order Description
T01 Check: Short to Ground/Interruption of Voltage Supply Circuit
• Engine running
• Increase engine speed to 3000 rpm
• Measure voltage between the following terminals:
Battery – Positive (+) terminal
&
Ground
Yes: T02
T02 Check: Short to Ground/Interruption of Voltage Supply Circuit
• Ignition OFF
• Measure voltage between the following terminals:
Battery – Positive (+) terminal
&
Ground
Yes: T03
T03 Check: Transition Resistance of Voltage Supply Circuit
• All consumers turned off
• Disconnect wiring harness connector from:
ECM
• Ignition ON
• Connect test lamp ( 10 W ) and multimeter in parallel and measure volt-
age between the following terminals:
ECM – Wiring harness connector (wiring harness side) terminal G88-50
&
Ground
Yes: T04
T04 Check: Transition Resistance of Voltage Supply Circuit
• Connect test lamp ( 10 W ) and multimeter in parallel and measure volt-
age between the following terminals:
Battery Positive (+) terminal
&
ECM – Wiring harness connector (wiring harness side) terminal G88-1,
G88-2, G88-3
Yes: E01
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-83
Nominal Value
13 ... 15 V
No: E05
greater than 11 V
No: E04
greater than 11 V
No: E03
greater than 11 V
No: E02