Suzuki Ignis Service Manual page 1739

6-3-80 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE)
C-02, Control Unit Hard- and Software
Test Table
Test Work Order Description
T01 Result: High Transition Resistance
• Check the following circuit for proper operation:
Ground connection of the control unit case
Yes: T02
T02 Check: Programming
• Ignition ON
• Repeat programming
Yes: E01
Result table
Result Cause Of Fault
E01 • Previous programming was faulty
E02 • Defective component:
ECM
NOTE:
If ECM is replaced, register vehicle specification into ECM by performing procedure
described in "ECM registration" in Section 6E3.
E03 • Following system/component is faulty:
Ground connection of the control unit case
Nominal Value
Test okay?
No: E03
Programming okay?
No: E02