Table of Contents
Advertisement
4A-14 FRONT DRIVE SHAFT
1
(A)
A
1
1
2
7) Confirm that wheel side boot is not stretched or contracted,
and then fasten boot big band (1) securely by using special
tool.
Special tool
(A) : 09943-55010 or 09943-57010
8) Place new wheel side boot small band (1) onto boot putting
band outer end (2) against forward rotation (3) as shown in
figure.
9) Confirm that wheel side boot is not stretched or contracted,
and then fasten boot small band (1) securely by using spe-
cial tool.
Special tool
(A) : 09943-55010 or 09943-57010
10) Install damper (1) on drive shaft according to dimension
specified below.
Damper installation position
"a" : 157 – 163 mm (6.18 – 6.42 in.)
11) Set new differential side boot small band (2) and differential
side boot (1) on shaft temporarily.
Advertisement
Table of Contents
