Rate Limit Commands; Table 4-49 Rate Limit Commands - SMC Networks SMC TigerStack III SMC6824M Management Manual

R L C
ATE IMIT OMMANDS
Example
The following shows mirroring configured from port 6 to port 11:
Console(config)#interface ethernet 1/11
Console(config-if)#port monitor ethernet 1/6
Console(config-if)#end
Console#show port monitor
Port Mirroring
-------------------------------------
Destination port(listen port):Eth1/1
Source port(monitored port)
Mode
Console#

Rate Limit Commands

This function allows the network manager to control the maximum rate for
traffic transmitted or received on an interface. Rate limiting is configured on
interfaces at the edge of a network to limit traffic into or out of the network.
Traffic that falls within the rate limit is transmitted, while packets that exceed
the acceptable amount of traffic are dropped.
Rate limiting can be applied to individual ports or trunks. When an interface
is configured with this feature, the traffic rate will be monitored by the
hardware to verify conformity. Non-conforming traffic is dropped,
conforming traffic is forwarded without any changes.
Command
rate-limit
4-186
:Eth1/6
:RX/TX

Table 4-49 Rate Limit Commands

Function
Configures the maximum input or output rate
for a port
Mode Page
IC 4-187