Show Access-Group; Snmp Commands - SMC Networks SMC TigerStack III SMC6824M Management Manual

show access-group

This command shows the port assignments of ACLs.
Command Mode
Privileged Executive
Example
Console#show access-group
Interface ethernet 1/2
IP standard access-list david
MAC access-list jerry
Console#

SNMP Commands

Controls access to this switch from management stations using the Simple
Network Management Protocol (SNMP), as well as the error types sent to
trap managers.
SNMP Version 3 provides security features that cover message integrity,
authentication, and encryption; as well as controlling user access to specific
areas of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or
accept the default), specify read and write access views for the MIB tree,
configure SNMP user groups with the required security model (i.e., SNMP
v1, v2c or v3) and security level (i.e., authentication and privacy), and then
assign SNMP users to these groups, along with their specific authentication
and privacy passwords.
Command
snmp-server
show snmp
snmp-server
community
snmp-server contact Sets the system contact string
Table 4-41 SNMP Commands
Function
Enables the SNMPv3 server
Displays the status of SNMP communications NE,
Sets up the community access string to permit
access to SNMP commands
C L
OMMAND INE
I
NTERFACE
Mode Page
GC 4-152
4-153
PE
GC 4-154
GC 4-154
4-151