Configuring Lacp Parameters - SMC Networks SMC TigerStack III SMC6824M Management Manual

Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
Flow control:
Port security:
Max MAC count:
Current status:
Created by:
Link status:
Port operation status:
Operation speed-duplex: 100full
Flow control type:
Member Ports: Eth1/1, Eth1/2, Eth1/3, Eth1/4,
Console#

Configuring LACP Parameters

Dynamically Creating a Port Channel –
Ports assigned to a common port channel must meet the following criteria:
• Ports must have the same LACP System Priority.
• Ports must have the same LACP port Admin Key.
• However, if the "port channel" Admin Key is set (
port Admin Key must be set to the same value for a port to be allowed
to join a channel group.
Note: If the port channel admin key (lacp admin key, page 4-194) is not
set (through the CLI) when a channel group is formed (i.e., it has a
null value of 0), this key is set to the same value as the port admin
key used by the interfaces that joined the group (lacp admin key, as
described in this section and on page 4-193).
100TX
00-04-E2-B3-16-D6
Up
Auto
10half, 10full, 100half, 100full
Enabled
Disabled
0
LACP
Up
Up
None
P C
ORT ONFIGURATION
), then the
page 4-194
4-179
3-125