Shutdown - SMC Networks SMC TigerStack III SMC6824M Management Manual

I C
NTERFACE OMMANDS
• To force flow control on or off (with the flowcontrol or no flowcontrol
command), use the no negotiation command to disable
auto-negotiation on the selected interface.
• When using the negotiation command to enable auto-negotiation, the
optimal settings will be determined by the capabilities command. To
enable flow control under auto-negotiation, "flowcontrol" must be
included in the capabilities list for any port
• Avoid using flow control on a port connected to a hub unless it is actually
required to solve a problem. Otherwise back pressure jamming signals
may degrade overall performance for the segment attached to the hub.
Example
The following example enables flow control on port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#flowcontrol
Console(config-if)#no negotiation
Console(config-if)#
Related Commands
negotiation (4-173)
capabilities (flowcontrol, symmetric) (4-174)

shutdown

This command disables an interface. To restart a disabled interface, use the
no form.
Syntax
[no] shutdown
Default Setting
All interfaces are enabled.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command allows you to disable a port due to abnormal behavior
(e.g., excessive collisions), and then reenable it after the problem has been
resolved. You may also want to disable a port for security reasons.
4-176