Stopbits; Disconnect - SMC Networks SMC TigerStack III SMC6824M Management Manual

stopbits

This command sets the number of the stop bits transmitted per byte. Use the
no form to restore the default setting.
Syntax
stopbits {1 | 2}
• 1 - One stop bit
• 2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#

disconnect

This command terminates an SSH, Telnet, or console connection.
Syntax
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
Command Mode
Privileged Exec
Command Usage
Specifying session identifier "0" will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an
SSH or Telnet connection.
C L
OMMAND INE
I
NTERFACE
4-23