Port Configuration; Displaying Connection Status - SMC Networks SMC TigerStack III SMC6824M Management Manual

C
ONFIGURING THE
CLI – This example assigns an IP and MAC ingress ACL to port 1, and an
IP ingress ACL to port 2.
Console(config)#interface ethernet 1/1
Console(config-if)#ip access-group david in
Console(config-if)#mac access-group jerry in
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#ip access-group david in
Console(config-if)#

Port Configuration

Displaying Connection Status

You can use the Port Information or Trunk Information pages to display
the current connection status, including link state, speed/duplex mode,
flow control, and auto-negotiation.
Command Attributes (Web)
• Name – Interface label.
• Type – Indicates the port type. (100BASE-TX, 1000BASE-GBIC,
100BASE-FX-S, 100BASE-FX-M, 1000BASE-T, or SFP)
• Admin Status – Shows if the interface is enabled or disabled.
• Oper Status – Indicates if the link is Up or Down.
• Speed Duplex Status – Shows the current speed and duplex mode.
(Auto, or fixed choice)
• Flow Control Status – Indicates the type of flow control currently in
use. (IEEE 802.3x, Back-Pressure or None)
• Autonegotiation – Shows if auto-negotiation is enabled or disabled.
• Trunk Member
• Creation
via LACP.
4. Port Information only.
5. Trunk Information only.
3-114
S
WITCH
4
– Shows if port is a trunk member.
5
– Shows if a trunk is manually configured or dynamically set
4-171
4-134
4-146