Power Over Ethernet Commands; Table 4-26 Poe Commands - SMC Networks SMC TigerStack III SMC6824M Management Manual

P E
OWER OVER

Power over Ethernet Commands

The commands in this group control the power that can be delivered to
attached PoE devices through the switch ports on the SMC6824MPE and
SMC6826MPE.
The switch's power management enables total switch power and individual
port power to be controlled within a configured power budget. Port power
can be automatically turned on and off for connected devices, and a per-port
power priority can be set so that the switch never exceeds its allocated power
budget. When a device is connected to a switch port, its power requirements
are detected by the switch before power is supplied. If the power required by
a device exceeds the power budget of the port or the whole switch, power is
not supplied.
Command Group
power mainpower
maximum allocation
power inline
compatible
power inline
power inline
maximum allocation
power inline priority Sets the priority for power supplied to specific
show power inline
status
show power
mainpower
4-90
C
THERNET OMMANDS

Table 4-26 PoE Commands

Function
Sets the maximum power available to all
switch ports
Provides power to pre-standard PoE devices GC
Turns power on and off for specific ports
Sets the maximum power available to specific
switch ports
ports
Displays the current status of power
management on specific ports or all ports
Displays the current status of power
management for switch
Mode Page
GC 4-91
4-91
IC 4-93
IC 4-93
IC 4-94
PE 4-95
PE 4-96