Mapping Cos Values To Acls; Table 3-16 Cos To Acl Mapping; Figure 3-97 Mapping Priority Settings To Ports/Trunks - SMC Networks SMC TigerStack III SMC6824M Management Manual

C
ONFIGURING THE
Web – Click Priority, Copy Settings. Select the source priority settings to
be copied, enter the source port or trunk number and choose the
destination interface/s to copy to, then click Copy Settings.

Figure 3-97 Mapping Priority Settings to Ports/Trunks

CLI – This feature not supported through the CLI.

Mapping CoS Values to ACLs

Use the ACL CoS Mapping page to set the output queue for packets
matching an ACL rule as shown in the following table. Note that the
specified CoS value is only used to map the matching packet to an output
queue; it is not written to the packet itself. For information on mapping
the CoS values to output queues, see page 3-204.
Queue
Priority
3-216
S
WITCH

Table 3-16 CoS to ACL Mapping

0
1,2
1
0,3
2
4,5 6,7
3