Configuring Https - SMC Networks SMC TigerStack III SMC6824M Management Manual

CLI – Specify all the required parameters to enable logon authentication.
Console(config)#authentication login radius
Console(config)#radius-server port 181
Console(config)#radius-server key green
Console(config)#radius-server retransmit 5
Console(config)#radius-server timeout 10
Console(config)#radius-server 1 host 192.168.1.25
Console(config)#exit
Console#show radius-server
Remote RADIUS server configuration:
Global settings:
Communication key with RADIUS server: *****
Server port number:
Retransmit times:
Request timeout:
Server 1:
Server IP address: 192.168.1.25
Communication key with RADIUS server: *****
Server port number: 181
Retransmit times: 5
Request timeout: 10
Console#config
Console(config)#authentication login tacacs
Console(config)#tacacs-server host 10.20.30.40
Console(config)#tacacs-server port 200
Console(config)#tacacs-server key green
Console(config)#exit
Console#show tacacs-server
Server IP address: 10.20.30.40
Communication key with tacacs server: green
Server port number: 200
Console(config)#

Configuring HTTPS

You can configure the switch to enable the Secure Hypertext Transfer
Protocol (HTTPS) over the Secure Socket Layer (SSL), providing secure
access (i.e., an encrypted connection) to the switch's web interface.
Command Usage
• Both the HTTP and HTTPS service can be enabled independently on the
switch. However, you cannot configure both services to use the same
UDP port.
U A
SER UTHENTICATION
181
5
10
4-98
4-102
4-102
4-103
4-103
4-101
4-104
4-98
4-105
4-106
4-106
4-107
3-75