Snmp-Server Enable Traps - SMC Networks SMC TigerStack III SMC6824M Management Manual

snmp-server enable traps

This command enables this device to send Simple Network Management
Protocol traps or informs (i.e., SNMP notifications). Use the no form to
disable SNMP notifications.
Syntax
[no] snmp-server enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure
notifications.
• link-up-down - Keyword to issue link-up or link-down notifications.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to configure
this device to send SNMP notifications, you must enter at least one
snmp-server enable traps command. If you enter the command with
no keywords, both authentication and link-up-down notifications are
enabled. If you enter the command with a keyword, only the notification
type related to that keyword is enabled.
• The snmp-server enable traps command is used in conjunction with
the snmp-server host command. Use the snmp-server host command
to specify which host or hosts receive SNMP notifications. In order to
send notifications, you must configure at least one snmp-server host
command.
• The authentication, link-up, and link-down traps are legacy notifications,
and therefore when used for SNMP Version 3 hosts, they must be
enabled in conjunction with the corresponding entries in the Notify
View assigned by the snmp-server group command (page 4-164).
C L
OMMAND INE
I
NTERFACE
4-159