Configuring Interface Settings - SMC Networks SMC TigerStack III SMC6824M Management Manual

CLI – This example shows general STA configuration and attributes for
port 5.
Console#show spanning-tree ethernet 1/5
Eth 1/ 5 information
--------------------------------------------------------------
Admin status:
Role:
State:
External path cost:
Internal path cost:
Priority:
Designated cost:
Designated port
Designated root:
Designated bridge:
Fast forwarding:
Forward transitions:
Admin edge port:
Oper edge port:
Admin Link type:
Oper Link type:
Spanning Tree Status:
Console#

Configuring Interface Settings

You can configure RSTP and MSTP attributes for specific interfaces,
including port priority, path cost, link type, and edge port. You may use a
different priority or path cost for ports of the same media type to indicate
the preferred path, link type to indicate a point-to-point connection or
shared-media connection, and edge port to indicate if the attached device
can support fast forwarding. (References to "ports" in this section means
"interfaces," which includes both ports and trunks.)
Command Attributes
The following attributes are read-only and cannot be changed:
• STA State – Displays current state of this port within the Spanning Tree.
(See Displaying Interface Settings on page 3-165 for additional
information.)
- Discarding - Port receives STA configuration messages, but does not
forward packets.
S T
PANNING REE
enabled
disable
discarding
200000
200000
128
200000
: 128.5
32768.0.0000E8AAAA00
32768.0.0004E2B316C0
enabled
0
enabled
enabled
auto
point-to-point
enabled
A C
LGORITHM ONFIGURATION
4-227
3-169