Using Dhcp/Bootp; Figure 3-7 Ip Interface Configuration - Dhcp - SMC Networks SMC TigerStack III SMC6824M Management Manual

C
ONFIGURING THE

Using DHCP/BOOTP

If your network provides DHCP/BOOTP services, you can configure the
switch to be dynamically configured by these services.
Web – Click System, IP Configuration. Specify the VLAN to which the
management station is attached, set the IP Address Mode to DHCP or
BOOTP. Click Apply to save your changes. Then click Restart DHCP to
immediately request a new address. Note that the switch will also broadcast
a request for IP configuration settings on each power reset.
Note: If you lose your management connection, make a console
connection to the Master unit and enter "show ip interface" to
determine the new stack address.
CLI – Specify the management interface, and set the IP address mode to
DHCP or BOOTP, and then enter the "ip dhcp restart" command.
Console#config
Console(config)#interface vlan 1
Console(config-if)#ip address dhcp
Console(config-if)#end
Console#ip dhcp restart
Console#show ip interface
IP address and netmask: 192.168.1.1 255.255.255.0 on VLAN 1,
and address mode:
Console#
3-22
S
WITCH

Figure 3-7 IP Interface Configuration - DHCP

DHCP.
4-171
4-280
4-282
4-283