Show Access-Group; Snmp Commands; Table 4-38 Snmp Commands - SMC Networks TigerSwitch SMC8612T2 Management Manual

show access-group

This command shows the port assignments of ACLs.
Command Mode
Privileged Executive
Example
Console#show access-group
Interface ethernet 1/11
IP standard access-list david
MAC access-list jerry
Console#

SNMP Commands

Control access to this switch from management stations using the Simple
Network Management Protocol (SNMP), as well as the error types sent to
trap managers.
Command
snmp-server
community
snmp-server contact Sets the system contact string
snmp-server location Sets the system location string
snmp-server host
snmp-sever enable
traps
show snmp

Table 4-38 SNMP Commands

Function
Sets up the community access string to
permit access to SNMP commands
Specifies the recipient of an SNMP
notification operation
Enables the device to send SNMP traps
(i.e., SNMP notifications)
Displays the status of SNMP
communications
SNMP C
OMMANDS
Mode Page
GC 4-150
GC 4-151
GC 4-151
GC 4-152
GC 4-154
NE, 4-155
PE
4-149