8.3.12.7
MAINTENANCE STATUS (3.6.7.)
Indicates which level of maintenance reminder is active.
In SIMATIC PDM, open the menu Diagnostics > Device Diagnostics, click on the Maintenance
tab, and check the Calibration Schedule Status window.
8.3.12.8
ACKNOWLEDGE STATUS (3.6.8.)
Indicates which level of maintenance reminder has been acknowledged.
In SIMATIC PDM, open the menu Diagnostics > Device Diagnostics, click on the Maintenance
tab, and check the Calibration Schedule Status window.
8.3.12.9
ACKNOWLEDGE (3.6.9.)
Purpose:
Description:
8.3.13
REMAINING SENSOR LIFETIME (3.7.)
Note
• Four sets of parameters allow you to monitor the Device/Sensor Lifetimes and set up
Maintenance/Service schedules, based on operating hours instead of a calendar-based
schedule, see REMAINING DEVICE LIFETIME (3.6) (Page 133), SERVICE SCHEDULE
(4.7.) (Page 140), and CALIBRATION SCHEDULE (4.8.) (Page 143).
• Performing a reset to Factory Defaults will reset all the Maintenance Schedule
parameters to their factory defaults.
• The device operates in years. To view Remaining Device Lifetime parameters in hours or
days (via SIMATIC PDM only) see LIFETIME EXPECTED (3.7.6.) (Page 137).
Factory setting:
Setting range
SITRANS LR560 (mA/HART)
Operating Instructions, 06/2017, A5E34647946-AD
Acknowledges the current maintenance reminder.
To acknowledge a reminder via SIMATIC PDM:
Open the menu Diagnostics > Device Diagnostics and click on the tab
•
Maintenance.
In the Calibration Schedule section, click on Acknowledge Warnings.
•
To acknowledge a reminder via the local control buttons or hand-held program-
mer:
Press RIGHT arrow twice to open parameter view and activate Edit Mode.
•
Press RIGHT arrow to acknowledge the reminder.
•
years
:
hours, days, years
1)
Parameter Reference
8.3 DIAGNOSTICS (3.)
135