Table of Contents
Advertisement
ADFM Commands
C-1
Introduction
This Appendix defines the commands used by the ADFM. These com-
mands let you set up and control the ADFM without using an external soft-
ware program such as our WinADFM program. However, we recommend
you use WinADFM to control the ADFM because entering commands di-
rectly from a terminal can be difficult. Most ADFM settings use factory-set
values (see Table C-13). If you change these values without thought, you
could ruin your deployment. Be sure you know what affect each command
has before using it. Call MGD if you do not understand the function of any
command.
In special cases these commands can be added to the Advanced window in
WinADFM. The ADFM will use these commands as part of the configura-
tion file if the Use Advanced check-box is enabled in the ADFM Operate
window. Again, only use commands if you know what affect the command
will have on your deployment.
This appendix does not list all of the commands available for the ADFM.
Only the commands that are required for a successful deployment are
documented. If you need information on other commands, contact MGD.
NOTE. This appendix applies to firmware version 6.37. When newer
firmware versions are released, some commands may be modified or
added. Read the README file on the upgrade disk or check MGD's web
site for the latest changes.
NOTE. The information in this Appendix is provided for reference purposes
only. Using WinADFM to develop the configuration file will ensure that the
ADFM is set up correctly. Users should consult with MGD if they believe
they need to use a customized command set or override the settings
generated by WinADFM.
ADFM Technical Manual (January 2000)
ADFM Commands
C
Appendix
page C-1
Advertisement
Table of Contents
