Ez - Sensor Source; Table C-5: Sensor Source Switch Settings - Teledyne ADFM Pro20 Technical Manual

EZ - Sensor Source:

Purpose:
Format:
Default
Range:
Description
Table C-5:
Field Value = 0
c Manual EC
d Vertical beam only
h Manual EH
p Manual EP
r Manual ER
s Manual ES
t Manual ET
Example
ADFM Technical Manual (January 2000)
The EZ-command selects the source of environmental sensor
data.
EZcdhprst
EZ1011111
Firmware switches (see description)
Setting the EZ-command firmware switches tells the ADFM
to use data from a manual setting or from an associated sen-
sor. When a switch value is non-zero, the ADFM overrides
the manual E-command setting and uses data from the appro-
priate sensor. If no sensor is available, the ADFM defaults to
the manual E-command setting. The following table shows
how to interpret the sensor source switch settings.
Sensor Source Switch Settings
Value = 1
Calculate using
ED, ES, and ET
Vertical beam
and secondary
depth sensor
Heading
Pitch (Tilt 1)
Roll (Tilt 2)
N/A
Transducer
Sampled
EZ1111101 means calculate speed of sound from readings,
use secondary depth sensor, transducer heading, internal tilt
sensors, and transducer temperature.
ADFM Commands
Value = 2
N/A
N/A
N/A
N/A
N/A
N/A
N/A
page C-17