MT - Modem Terminal
Purpose:
Format:
Description:
MZ - Modem Reset
Purpose:
Format:
Description:
ADFM Technical Manual (January 2000)
given remotely over the Modem interface since turning off the
Modem would cause communications with the ADFM to be
lost.
Allows for a direct connection to the modem.
MT
Entering 'MT' at the ADFM command prompt will cause the
ADFM to go into a mode where it passes all input via the RS-
232 to the Modem, and passes all input from the Modem to
the RS-232. This gives the operator connected to the RS-232
interface a direct connection to the Modem, and is just like
talking to a local Modem from a PC. The operator can give
any valid 'AT' commands and see all responses from the Mo-
dem, including dialing out and communicating with a host.
This command is normally only used for troubleshooting, and
is disabled if given remotely over the Modem interface.
Resets the modem.
MZ
This command will cause the ADFM to reset the Modem to its
factory default settings. See the Modem instruction manual
for more details.
ADFM Commands
page C-21