5.3.3
Focus Motion
Axis number 2 is the focus axis. The alias for this axis is the letter f. Commands include:
Move to infinity focus: /MPAf 100, u
•
Move a small amount toward a near object: /MPRf -25
•
Move a small amount toward a far object: /MPRf 25
•
Move a large amount toward a near object: /MPRf -200
•
Move a large amount toward a far object: /MPRf 200
•
Get the current focus axis position in encoder counts: /GMSf[2] 1
•
5.3.4
Miscellaneous Commands
Additional helpful commands include:
Get the lens temperature: /GTV
•
Reset the Teledyne FLIR controller: /RST0 NEOS
•
Initiate Home sequence for an axis: /HOMx where x is the axis number specified above
•
Turn On temperature compensation: /MDF[4] 2
•
Turn Off temperature compensation: /MDF[4] 0
•
Turn On range compensation: /MDF[5] 2
•
Turn Off range compensation: /MDF[5] 0
•
Document M-008 Revision A. Approved for public release: Teledyne FLIR approved [FLIRGTC-SBA-018].
© 2023 Teledyne FLIR
BOSON+ CZ 14-75 USER MANUAL
Page 8