5-5.3 Field Test - Teledyne ADFM Pro20 Technical Manual

• Lists the ADFM's serial number and the transducer and electron-
• Determines if an internal recorder is present. Performs a "Re-
• Determines if a modem is present. Performs a "Modem Test" and
• Performs a "Systems Test" and returns an "OK" or an error decla-
• Performs a Look-up Table "Checksum Test" and returns an "OK"
• Determines the value of three operating voltages in the ADFM.
5-5.3 Field Test
This test performs internal ADFM system checks that should be performed
after installation. This test does the following.
• Establishes communications and determines if the ADFM wake-
• Determines if the receive path is operating properly and returns a
• Determines if the transmit path is operating properly and returns
• Determines if the electronics signal-processing path is operating
ADFM Technical Manual (January 2000)
ics firmware versions.
corder Test" and returns an "OK" or an error declaration.
returns an "OK" or an error declaration.
ration.
or an error declaration.
• Battery Voltage,
• VDD1 Voltage (logic),
• Transducer Voltage.
up message contains any errors. ADFM is "ready".
Pass or Fail with an error. This test will fail if the transducer is
not connected to the electronics case.
a Pass or Fail with an error.
properly and returns a Pass or Fail with an error. This test will
fail if the transducer is not underwater.
ADFM Test Procedures
page 5-9