Boot Auto-Copy-Sw - Cisco Catalyst 3560-X Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

boot auto-copy-sw

Note
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Related Commands
OL-21522-02
Downloaded from www.Manualslib.com
Use the boot auto-copy-sw global configuration command from the stack master to enable the automatic
upgrade (auto-upgrade) process. It automatically upgrades a switch in version-mismatch (VM) mode by
copying the running software image on any stack member or by copying a tar file image in switch stack
flash memory. Use the no form of this command to disable the auto-upgrade process.
boot auto-copy-sw
no boot auto-copy-sw
This command is supported only on Catalyst 3750-X switches.
This command has no arguments or keywords.
Enabled.
Global configuration
Release
12.2(53)SE2
A switch in VM mode is a switch that has a different minor version number than the version on the switch
stack. A switch in VM mode cannot join the switch stack as a fully functioning member. If the switch
stack has an image that can be copied to a switch in VM mode, the auto-upgrade process automatically
copies the image from a stack member to the switch in VM mode. The switch then exits VM mode,
reboots, and joins the switch stack as a fully functioning member.
The auto-upgrade process affects only switches in VM mode. It does not affect existing stack members.
Command
show boot
show version
manuals search engine
Modification
This command was introduced.
Description
Displays the settings of the boot environment variables.
Displays version information for the hardware and firmware.
Catalyst 3750-X and 3560-X Switch Command Reference
boot auto-copy-sw
2-67