Operation
6.4 Display
See also
Measured value status (Page 116)
6.4.4
Mode display
Description
The selected active mode is shown in the mode display.
Display
Figure 6-4
In the example, a damping of 0.2 seconds was set in mode 4.
6.4.5
Status display
Description
The arrows of the status display have a different meaning depending on the mode setting.
The table below shows the meanings of the arrows in the respective functions.
Meaning
Table 6- 3
Function
Adjusting start of
scale value
Adjusting full scale
value
Adjusting damping
74
Example for mode display
Meaning of the arrow displays
Mode
Display
2
if the upper current limit is
exceeded
3
if the upper current limit is
exceeded
4
if the upper damping value is
exceeded
only for the pressure device version
Display
if the value falls below the
lower current limit
if the value falls below the
lower current limit
if the value falls below the
lower damping value
only for the pressure device
version
SITRANS P DS III with HART
Operating Instructions, 06/2013, A5E00047092-09