Mode Display; Status Display - Siemens SITRANS P300 Operating Instructions Manual

See also
Measured value status (Page 7-10)
6.4.4

Mode display

Description
The selected active mode is shown in the mode display.
Display
Figure 6-4
In the example, a damping of 0.2 seconds was set in mode 4.
6.4.5

Status display

Description
The arrows of the status display have a different meaning depending on the mode setting.
The table below shows the meanings of the arrows in the respective functions.
Meaning
Table 6-3
Function
Adjusting zero point
Adjusting limit point
Adjusting damping
Blind adjusting zero point
SITRANS P300 with HART communication
Operating Instructions, 06/2005, A5E00359579-02
Example for mode display
Meaning of the arrow displays
Mode
2
3
4
5
Display
exceeds of the upper current
limit
exceeds of the upper current
limit
exceeds of the upper
damping value
only for device type pressure
exceeds of the upper sensor
limit
Operation
6.4 Digital display
Display
exceeds of the lower current
limit
exceeds of the lower current
limit
exceeds of the lower damping
value
only for device type pressure
exceeds of the lower sensor
limit
6-7