Siemens SITRANS P DS III Operating Instructions Manual page 101

Requirement
You are familiar with the correct operation of the transmitter and the associated safety notes.
You have already selected the desired measured value display via HART.
Procedure
To adjust the physical unit, proceed as follows:
1. Set mode 14.
2. Select a unit.
3. Save with the [M] button.
Instructions for selecting the unit
● Unit selection depends on the type of measurement set. For example, only pressure units
● The displayed measured value is always converted into the new unit. "9.9.9.9.9" appears
● The selected unit is visible on the display in the measuring mode only if you have
Units
Table 6- 7
Pressure units
bar
mbar
mm water column (20°C / 68°F)
Inch water column (20°C / 68°F)
Feet water column (20°C / 68°F)
mm mercury column
Inch mercury column
mm water column (4°C / 39 °F)
Inch water column (4°C / 39°F)
SITRANS P DS III with HART
Operating Instructions, 06/2013, A5E00047092-09
Press the [↑] and [↓] buttons simultaneously to set the unit to the first value in the
following table depending on the measuring mode set.
are available in "Pressure" measuring mode and only level units are available in the
"Level" measuring mode.
on the display when its display capacity is exceeded.
selected the display of a physical unit via HART. "mA" or "%" will be displayed if you have
not selected mode 13, "Measuring mode".
Units available for pressure
Display Pressure units
bar Psi
mbar Pa
mmH2O KPa²
inH2O MPa
FTH2O g/cm2
mmHG Kg/cm2
in_HG Torr
m4H2O ATM
i4H2O
Operation
6.5 Local operation
Display
PSi
Pa
KPa
MPa
Gcm2
KGcm2
TORR
ATM
101