Measured Value Display - Siemens SITRANS P DS III Operating Instructions Manual

7.13

Measured value display

Introduction
You can use this function to set one of three options for the device display:
● Display in mA
● Display in % (of the set measuring range)
● Display in a physical unit
Table 7- 4
DV
0
1
2
3
4
5
6
7
8
9
Points to note for "Pressure" DV
If the device variable (DV) is set to "Pressure", you can configure the displayed pressure unit
with an extension, GAUGE (G) or ABS (A). The add-on has no effect on the real measured
value.
To do so, select the option Gauge or Absolute under the "Pressure display type" menu item.
There are two options for the display:
SITRANS P DS III with HART
Operating Instructions, 06/2013, A5E00047092-09
Display of measuring mode/device variables
Description
Pressure
Sensor temperature
Electronics temperature
Pressure (untrimmed)
Level
Volume
Mass
Volumetric flow rate (not relevant to gauge or absolute pressure)
Mass flow rate (not relevant to gauge or absolute pressure)
Users
Operating functions through HART
7.13 Measured value display
127