Unit - Siemens SITRANS P DS III Operating Instructions Manual

Operation
6.5 Local operation
Introduction
In mode 13, adjust the following types of measured value display:
● mA
● %
● Display of the PV selected via HART. (Default setting: P pressure)
Table 6- 6
Display
P
t-SE
t-EL
P-UNC
LEVEL
Vol
MASS
V-Flo
M-Flo
CUSt
Condition
You are familiar with the correct operation of the transmitter and the associated safety notes.
Procedure
To select the display type, proceed as follows:
1. Set mode 13.
2. Select the measured value display.
3. Save with the [M] button.
See also
Measured value display (Page 127)
6.5.13

Unit

Introduction
In mode 14, select the physical unit in which the measured value display of the device
should be shown.
100
Display of measuring mode/device variables
DV Meaning
0 Pressure
1 Sensor temperature
2 Electronics temperature
3 Pressure (untrimmed)
4 Level
5 Volume
6 Mass
7 Volumetric flow rate (not relevant for gauge or absolute pressure)
8 Mass flow rate (not relevant for gauge or absolute pressure)
9 Users
SITRANS P DS III with HART
Operating Instructions, 06/2013, A5E00047092-09