Structure - Siemens SITRANS P DS III Operating Instructions Manual

Description

3.3 Structure

3.3 Structure
Depending on a customer-specific order, the device comprises different parts.
①
Key cover
②
Cover (front), optionally with inspection window
③
Display (optional)
④
Measuring point label
⑤
Retaining screw; twist proofing of the measuring cell
in relation to the electronics enclosure
⑥
Process connection
⑦
Nameplate (general information)
Figure 3-2 View of the transmitter: Left: Front right: Rear view
● The electronics enclosure is made of die cast aluminum or precision cast stainless steel.
● The housing has a removable circular cover at the front and the back.
● Depending on the device version, the front cover
window. You can read the measured values straight off the digital display through this
inspection window.
● The cable inlet
right-hand one can be used. The unused opening is closed with a blanking plug
● The protective conductor terminal/equipotential bonding terminal
of the enclosure.
● The electrical terminal compartment
when you remove the back cover
22
⑧
⑨
⑩
⑪
⑫
⑬
⑧
to the electrical terminal compartment is at the side; either the left or
⑩
⑨
.
Cable inlet, optionally with cable gland
Cover (rear) for electrical terminal compartment
Electrical terminal compartment
Protective conductor connector/equipotential
bonding terminal
Nameplate (approval information)
Blanking plug
②
may be designed as an inspection
for the auxiliary power and shield is accessible
Operating Instructions, 06/2013, A5E00047092-09
⑬
.
⑪
is located at the back
SITRANS P DS III with HART