Display Counters Per Vpi/Vci; Gvp: Get Counters Per Vpi/Vci - 3Com CoreBuilder 9000 User Manual

212 C 8: V
HAPTER IEWING
Display Counters Per
VPI/VCI
S
TATISTICS
Display total cells through a connection specified by its VPI/VCI, presented
according to the setting of the CLP bit. If the call is P2M (Point to
Multipoint), the transmit or receive information is not always applicable.
Command Actions
Enter the menu sequence: (4) STS: Statistics
Enter a parameter at the prompt
Parameter
Port ID
VPI
VCI
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
4 2 3 1.1.1 3 200
The following message is displayed:
ATM Statistics per VPI/VCI:
---------------------------
Ingress cells with clp0 set:
Ingress cells with clp1 set:
Egress cells with clp0 set:
Egress cells with clp1 set:
(2) ATM: ATM layer

(3) GVP: Get counters per vpi/vci

Format or Range
<slot.group.port>
Perform menu item (3) CON\ (2) RTG\ (1) CLL
to get the VPI/VCI values for a call.
Perform menu item (3) CON\ (2) RTG\ (1) CLL
to get the VPI/VCI values for a call.
4 2 3 [parameters]
The total number of cells through a connection is
displayed according to the setting of the CLP bit.
Information is displayed as shown in the example.
2
1
2
3