Entering Multiple Parameters; Quick Key Functions - 3Com CoreBuilder 9000 User Manual

Entering Multiple
Parameters

Quick Key Functions

When a command has more than one parameter, you can enter them all
on the same command line with blanks in between or you can enter
some or all of them on separate command lines. If you do not enter them
all on one line, you are repeatedly prompted for the remaining
parameters.
If you enter an illegal character or string (such as an out-of-range
parameter), the LMA display responds with an error message which is
indicated by a three-asterisk (***) prefix.
The following quick key functions are available when you work with the
management menus. Table 9 lists functions for navigating in the menu
system; Table 10 lists aids for editing parameters.
Table 9 Menu Navigation Functions
To go
To the Main Menu from any point
To the previous menu
Back and forth within the command line
To the beginning of the command line
To the end of the command line
Table 10 Editing Aids
To perform this task
Clear the value of the parameter that you just entered
Clear the values of all the parameters in the list that you
just entered
Retrieve a previous command
Get the next command
Delete the character that precedes the insertion point
Delete the character that follows the insertion point
Toggle between Insert and Overwrite modes
Clear the command line
Escape from prompt
The LMA Menu System
Type or Press
\
-
Left/Right Arrows
Home
End
Type or Press
<
>
Up arrow
Down arrow
Backspace
Del
Ins
5
$
53