Update ILMI Channel
Polling Status
Update and save the channel polling facility status for the specified port
in the CoreBuilder 9000 ATM Enterprise Switch.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Port ID
ILMI polling
enable/disable
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 4 2 3.1.2
The following message is displayed:
ILMI polling is set to ENABLED.
The polling status of port 3.1.2 is enabled and is saved to flash.
(1) SET: Switch Setup
(8) IME: ILMI Setup
(4) POL: Polling Setup
(2) SST: Set&Save Polling Status
Format or Range
<slot.group.port>
0 to disable ILMI polling
1 to enable ILMI polling
1 1 8 4 2 [parameters]
ILMI polling for the selected port is updated and
saved.
ILMI polling is set to
<ENABLED/DISABLED>.
1
ILMI Setup
129