Set Password To Factory Default; Pas: Set Password Configuration To Factory Defaults - 3Com CoreBuilder 9000 User Manual

64 C 5: C
HAPTER ONFIGURING THE
Set Password to
Factory Default
P
LATFORM
Reset the passwords to their factory default settings for the
CoreBuilder 9000 ATM Enterprise Switch. These are, for each type of
user: read access, write access, and administer access. For more
information on access levels, see the CoreBuilder 9000 ATM Switch Fabric
Module Getting Started Guide.
To accept the default password, press Enter.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
Confirm reset
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 1 4
The following prompt is displayed:
Do you really want to reset config? [y/n]
Enter y to confirm. The following message appears:
Password configuration was set to defaults.
The passwords are reset to their factory values.
(1) SYS: Platform Configuration
(1) SET: Switch Setup
(1) PAS: Password Setup
(4) PAS: Set Password configuration
to factory defaults
Format or Range
y or n
1 1 1 4 [parameters]
The passwords are reset to their factory default values.
Password configuration was set to
defaults.