Update Lec/Lecs Communication Channel - 3Com CoreBuilder 9000 User Manual

Update LEC/LECS
Communication
Channel
Update the LECS-via-ILMI parameter for the specified port in the
CoreBuilder 9000 ATM Enterprise Switch. If this parameter is enabled, the
LEC communicates on the channel VPI/VCI = (0/16) with the ILMI MIB. It
submits an inquiry to obtain the LECS address. If this parameter is
disabled, the LEC connects to the LECS using the well-known address or
via the preconfigured LECS address in the LEC.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Port ID
LECS-via-ILMI
enable/disable
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 3 2 3.1.2
The following message is displayed:
LECS via ILMI is set to ENABLED.
The LECS-via-ILMI status of port 3.1.2 is enabled.
(1) SET: Switch Setup
(8) IME: ILMI Setup
(3) MIB: ILMI MIB View Setup
(2) SET: Set LECS via ILMI
ON/OFF Status
Format or Range
<slot.group.port>
0 to disable LECS-via-ILMI
1 to enable LECS-via-ILMI
1 1 8 3 2 [parameters]
The LECS-via-ILMI status is updated for the selected
port.
LECS via ILMI is set to
<ENABLED/DISABLED>.
1
ILMI Setup 127