3Com CoreBuilder 9000 User Manual page 271

Redundant ELANs Specific Parameters
Table 32 describes the ELANs specific parameters.
Table 32 Redundant ELANs Specific Parameters
Parameter
ELAN name
ELAN status
ELAN State
State start time (Sec)
Number config
requests O.K.
Number config
requests failed
Primary LES Id
Secondary LES Id
LAN Emulation Redundancy
Description
The ELAN name.
The status of the ELAN. This can be:
Operational The ELAN is operating normally.
New A newly created ELAN that has not
yet been processed by the LECS.
Init A newly created ELAN that is in the
process of becoming operational.
Old The ELAN is in the process of
becoming inoperable.
The state of the ELAN. This can be Primary, Secondary, In
Check (when the ELAN is in transient state) or No LES.
The absolute time the CoreBuilder
Switch was started (in seconds).
The number of configuration requests for this ELAN that
were okayed.
The number of configuration requests for this ELAN that
were failed. A request can fail if the ELAN State is 'NO LES',
meaning no LES is connected.
The Id of the primary LES.
The Id of the secondary LES.
271
®
9000 ATM Enterprise