Update Default Gateway Ip Address; Sgw: Set Default Gateway - 3Com CoreBuilder 9000 User Manual

Update Default
Gateway IP Address
Update the Default Gateway address. The default factory Default
Gateway IP address is
The default gateway IP address is changed after the next reboot.
Command Actions
Enter the menu sequence: (1) SYS: Platform Configuration
Enter a parameter at the prompt
Parameter
Default gateway address Valid IP address
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 2 3 2 100.1.0.254
The following message is displayed:
Default Gateway address was successfully set for the next
reboot.
The Default Gateway IP address is updated to 100.1.0.254 and takes
effect after the next reboot.
Setting Up for Management
.
151.104.78.20
(1) SET: Switch Setup
(2) MNG: Management Setup
(3) GWY: Default Gateway Setup

(2) SGW: Set Default Gateway

Format or Range
1 1 2 3 2 [parameters]
The default gateway address is updated.
Default Gateway address was
successfully set for the next reboot.
71