Setting The Virtual Path Identifier; Setting The Virtual Channel Identifier - 3Com CoreBuilder 2500 Software Installation And Release Notes

52 A B: A
PPENDIX DMINISTERING
Setting the Virtual
Path Identifier
Setting the Virtual
Channel Identifier
ATM
For each ATM port, you can set the virtual path identifier (VPI) used by
UME for the Interim Local Management Interface (ILMI). To set the VPI:
1 From the top level of the Administration Console, enter:
atm ume vpi
You are prompted for an ATM port.
2 Enter the ATM port for which you want to set the virtual path identifier.
3 Enter the new value for the VPI.
The new VPI takes effect after the port has been disabled and then
enabled.
You can set the virtual channel identifier (VCI) used by UME for the
Interim Local Management Interface (ILMI). To set the VCI:
1 From the top level of the Administration Console, enter:
atm ume vci
You are prompted for an ATM port.
2 Enter the ATM port for which you want to set the virtual channel
identifier.
3 Enter the new value for the VCI.
The new VCI takes effect after the port has been disabled and then
enabled.