WEC8500/8050 Operation Manual
5.1.4
Managing Root Service
To provide a wireless LAN service where cable installation is difficult, a W-EP AP can be
configured as a repeater mode to relay wireless LAN traffics. To configure this kind of
network, the Repeater AP and Root AP are required. The Repeater AP is working as a
wireless terminal and the Root AP connects a Repeater AP to a wireless terminal for
connection to the APC.
The root AP must be enabled with the repeater service to allow repeater AP connections.
Configuration using CLI
1) Go to configure apc configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc#
2) Enable or disable the repeater service. The repeater service must be enabled for the
repeater AP to connect to the root AP.
repeater-service: Enabled
no repeater-service: Disabled
3) Use the 'show wlan detail repeater' command to check the root WLAN settings.
WEC8500/configure/apc# show wlan detail repeater
[Changing to Root AP]
The procedure of changing a W-EP AP to a Root AP is as follows:
1) Go to configure mode of CLI.
WEC8500# configure terminal
2) Check the registered AP list.
WEC8500/configure# show ap summary
3) Go to AP configuration mode to change to a Root AP.
WEC8500/configure# ap ap_1
Samsung Electronics America
Version 5.2
page 198 of 533