Samsung WEC8500 Operation Manual page 159

WEC8500/8050 Operation Manual
4.2.2.4 Role-based Access Control Configuration of Remote AP Group
If the remote AP is running in local switching mode, the ACL settings between the APC
and the AP must be synchronized. The ACL settings are automatically synchronized when
the AP capwap runs. However, if the operator changes ACL of the APC, the ACL settings
must be synchronized as shown below.
Configuration using CLI
Perform the following commands to synchronize the settings for APs of all remote groups:
WEC8500# configure terminal
WEC8500/configure# rbac
WEC8500/configure/rbac# sync-config
Perform the following commands to synchronize the settings for APs of a specific remote
group:
WEC8500# configure terminal
WEC8500/configure# remote-ap-group rmt_grp_01
WEC8500/configure/remote-ap-group rmt_grp_01# sync-rbac-config
Synchronization result can be checked as shown below.
WEC8500# show rbac config summary
GRP_ID GRP_NAME Role Config File Name
====== ========= ==========================
1
etc/rmtapgrp/rbac_cfg_rmtapgrp1_20140307101643076655.tar
2
Samsung Electronics America
rmt_grp_01
rmt_grp_02 etc/rmtapgrp/rbac_cfg_20140305094752849046.tar
Version 5.2
page 159 of 533