Figure 137. Dpc Settings - Samsung WEC8500 Operation Manual

WEC8500/8050 Operation Manual
4) Execute the following command to change the Received Signal Strength Indication
(RSSI) threshold for neighbor AP. The default value is -70 (dBm).
WEC8500/configure/rrm/80211a/dpc# rssi-threshold [value]
5) If you need to change the RSSI threshold for the station, execute the following command.
The default value is -70 (dBm). This parameter is used only in the DCS-DPC joint
algorithm.
WEC8500/configure/rrm/80211a/dpc# rssi-threshold-for-stn [value]
6) Execute the following command to change the execution interval. The default value is
600 (seconds).
WEC8500/configure/rrm/80211a/dpc# periodic-interval [value]
7) Execute the following command to change the Tx Power range which is automatically
set by DPC. The default minimum is 16 for 80211a and 12 for 80211b.
The default maximum is 20 for both 80211a and 80211b.
WEC8500/configure/rrm/80211a/dpc# txPower min [value] max [value]
8) Check the settings using the 'show rrm config-summary' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Radio>  <802.11a/n/ac> or <802.11b/g/n>  <RRM> menu in the sub-menus.
Enable or disable the DPC in the SERVICE field in Dynamic TX Power Control.
Samsung Electronics America

Figure 137. DPC settings

Version 5.2
page 272 of 533