WEC8500/8050 Operation Manual
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Access Points> AP selection <General> menu in the sub-menus.
After selecting the AP MODE NAME item, click the <Apply> button to apply the
configuration.
4.2.4.4
AP CLI Access Account
The APC operator can add or remove account information relating to the AP CLI. When the
APC is first installed, a default account is provided (id: root, password: samsung).
Up to three AP CLI accounts can be added, and at least one account must be configured.
Therefore, if there is only one remaining account, it cannot be deleted.
(* While each account may be in any of the three available levels (Administrator/Operator/
Monitor), there are currently no functional differences for the APs.)
Configuration using CLI
Execute the following commands to configure the AP access account.
1) Go to configure APC mode of CLI.
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc #
Samsung Electronics America
Figure 78. AP mode configuration
Version 5.2
page 169 of 533