Pim Configuration - Samsung WEC8500 Operation Manual

WEC8500/8050 Operation Manual
3.7.2

PIM Configuration

As a multicast layer3 transmission protocol, the PIM has two modes, i.e. Dense mode and
Sparse mode. The WEC8500 supports only PIM Sparse mode and the PIM Sparse mode
can be configured for each interface.
Configuration using CLI
1) Go to configure of CLI  mode where you want to perform configuration.
WEC8500# configure terminal
WEC8500/configure# interface ge2
2) Perform PIM configuration.

ip pim sparse-mode: Enable

no ip pim sparse-mode: Disable
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <Multicast>  <PIM-SM> menu in the sub-menus. When you click the
<Add> or <Delete> button, you can add or delete PIM-SM configuration.
Follow the below procedure to add a PIM.
1) In the PIM-SM initial window, click the <Add> button.
2) Click the <Select Interface> button.
Samsung Electronics America
Figure 46. PIM-SM Configuration Window (1)
Figure 47. PIM-SM Configuration Window (2)
Version 5.2
page 123 of 533