Dpc Configuration - Samsung WEC8500 Operation Manual

WEC8500/8050 Operation Manual
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Radio>  <802.11a/n/ac> or <802.11b/g/n>  <RRM> menu in the sub-menus.
Enable or disable the RRM service at the top of the menu. The RRM can be set in either
802.11a/n/ac screen or 802.11b/g/n screens. Configure priorities between the neighbor list
of each Wlan at the bottom of the menu.
7.4.2

DPC Configuration

This section describes the setting options of the DPC function which automatically sets the
Tx Power of the AP.
Configuration using CLI
1) Go to configure  rrm configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# rrm
2) Go to the wireless section where you want to change the settings.
WEC8500/configure/rrm# 80211a
3) Set the DPC function. Enter the dpc setting mode and set it to 'enable'. Use the 'no'
parameter to disable the mode. The function operates only when the RRM is set to
Enable.
WEC8500/configure/rrm/80211a# dpc
WEC8500/configure/rrm/80211a/dpc# enable
Samsung Electronics America
Figure 136. RRM configuration window
Version 5.2
page 271 of 533