Speed Feedback Filter; Backlash Compensation - YASKAWA SGD7S Product Manual

8.12 Additional Adjustment Functions

8.12.6 Speed Feedback Filter

Pn009
Important

8.12.6 Speed Feedback Filter

You can set a first order lag filter for the speed feedback in the speed loop. This ensures
smooth changes in the feedback speed to reduce vibration. If a large value is set, it will
increase the delay and make response slower.
Pn308

8.12.7 Backlash Compensation

Outline
If you drive a machine that has backlash, there will be deviation between the travel distance in
the position reference that is managed by the host controller and the travel distance of the
actual machine. Use backlash compensation to add the backlash compensation value to the
position reference and use the result to drive the Servomotor. This will ensure that the travel
distance of the actual machine will be the same as the travel distance in the host controller.
Note: Backlash compensation can be used only with a Rotary Servomotor.
Backlash compensation value
8-72
Parameter
 
n. 0
Use speed detection 1.
(default setting)
 
n. 1 Use speed detection 2.
If the speed detection method is changed, the response characteristic of the speed loop will also
change. Servo tuning must therefore be performed again.
Speed Feedback Filter Time Constant
Setting Range
0 to 65,535
(0.00 ms to 655.35 ms)
Reference travel distance
Machine shaft
Reference travel
Motor shaft
Motor shaft
Backlash (play due to mechanical tolerance)
Meaning
Setting Unit Default Setting
0.01 ms
(0.00 ms)
distance
Forward reference direction
Machine axis (e.g., table)
When Enabled
After restart
When Enabled
0
Immediately
Classification
Tuning
Classification
Setup