Resetting Alarms; Displaying The Alarm History - YASKAWA SGD7S Product Manual

14.2 Alarm Displays

14.2.3 Resetting Alarms

14.2.3 Resetting Alarms

If there is an ALM (Servo Alarm) signal, use one of the following methods to reset the alarm
after eliminating the cause of the alarm.
Important
Resetting Alarms with I/O Communications
Refer to the following section for details on resetting alarms with I/O communications.
13.2.1
Resetting Alarms Using the Digital Operator
Press the ALARM RESET Key on the Digital Operator. Refer to the following manual for details
on resetting alarms.
Σ-7-Series Digital Operator Operating Manual (Manual No.: SIEP S800001 33)

14.2.4 Displaying the Alarm History

The alarm history displays up to the last ten alarms that have occurred in the SERVOPACK.
Note: FL-1 to FL-6 are not displayed in the alarm history.
Preparations
No preparations are required.
Applicable Tools
The following table lists the tools that you can use to display the alarm history and the applica-
ble tool functions.
Digital Operator
SigmaWin+
Operating Procedure
Use the following procedure to display the alarm history.
1.
Select Alarm - Display Alarm from the menu bar of the Main Window of the SigmaWin+.
The Alarm Display Dialog Box will be displayed.
2.
Click the Alarm History Tab.
The following display will appear and you can check the alarms that occurred in the past.
14-42
Be sure to eliminate the cause of an alarm before you reset the alarm.
If you reset the alarm and continue operation without eliminating the cause of the alarm, it may
result in damage to the equipment or fire.
on page 13-5
I/O Communications
Tool
Fn000
Alarm − Display Alarm
Alarm number: Alarm name
Alarms in order of occurrence (Older
alarms have higher numbers.)
Function Reference
Σ
-7-Series Digital Operator Operating Manual
(Manual No.: SIEP S800001 33)
Operating Procedure on page 14-42