Wiring Reactors For Harmonic Suppression - YASKAWA SGD7S Product Manual

E-7-series ac servo drive, e-7s servopack, command option attachable type with devicenet module

Hide thumbs Also See for SGD7S:

Table of Contents

Wiring Reactors for Harmonic Suppression

You can connect a reactor for harmonic suppression to the SERVOPACK when power supply

harmonic suppression is required. Refer to the following manual for details on harmonic reac-

Σ-7-Series Peripheral Device Selection Manual (Manual No.: SIEP S800001 32)

Refer to the following figures to connect reactors.

SERVOPACK with Three-Phase,

200-VAC Power Supply Input

Note: 1. Connection terminals

Remove the lead wire and connect a DC Reactor.

2. Reactors are optional products. (Purchase them separately.)

3. You cannot connect a DC Reactor to a SERVOPACK with a single-phase, 100-VAC power supply input.

2 for a DC Reactor are connected when the SERVOPACK is shipped.

4.3 Wiring the Power Supply to the SERVOPACK

SERVOPACK with Single-Phase,

100-VAC Power Supply Input

Sgdv-oca04a Sgdv-oca05a